Star-M No.50A drill rig

Use this drill stand from Star-M to drill constant, straight holes or holes in an exact square . It is almost impossible to drill by hand at a constant square . With this stand, this is possible up to 45 degrees.

Where a pillar drill is normally required, this stand can be the solution for carrying out flexible work. This stand has its own mounting shank with a shank diameter of 6.35 mm. The stand can be used with a standard (cordless) drill. The drill stand can be used with drill bits with a shank diameter of 1.5 mm to 10 mm and a maximum length of 210 mm.

The large opening in the base plate allows a good view of the drill hole during use. This base plate also has a V-groove on two sides. This makes it easier to drill into bars and pipes. The stand can also be attached to a beam using the additional steel screws.

The stand has a depth adjustment ring on both arms of the drill chuck guide as standard. This makes it possible to set the stand precisely to the desired drilling depth.

This stand is suitable for drill bits with a maximum diameter of 54 mm. The recommended maximum speed is 3,000 rpm.

Article-No.50A