Star-M No.5SA auger bit set 6, 9, 12 mm

Drill effortlessly with this auger bit set from Star-M. The design of this bit allows for efficient evacuation of chips and other drilling waste during use. Thanks to the open spiral, the drill bit is also less susceptible to overheating. This makes it possible to drill deeper and longer than with a conventional drill bit.

This practical set contains the following drill bits:

• • 6 mm - Length: 90 mm, Maximum drilling depth: 50 mm, Shank diameter: 6.35 mm, Shank: hexagonal

• • 9 mm - Length: 100 mm, Maximum drilling depth: 60 mm, Shank diameter: 6.35 mm, Shank: hexagonal

• • 12 mm - Length: 100 mm, Maximum drilling depth: 60 mm, Shank diameter: 6.35 mm, Shank: hexagonal

As these drill bits from Star-M are made from high-quality Japanese carbon steel, they can be used in all types of softwood and European hardwood such as ash, beech and oak. In addition, the auger bits are ideal for professional and even industrial use.

The cutting edge is designed with maximum precision and sharpened like a chisel that rotates around the tip of the wire. As a result, this drill removes the wood cleanly layer by layer. In addition, the sharpened and burr-free tip pulls the drill bit into the wood, so that practically no pressure is required and particularly precise positioning is possible.

These auger bits are suitable for use with an electric drill. Use a maximum speed of 3,000 rpm for all auger bits in the set. In addition, all auger bits in the set can also be used manually in combination with item 38K.

Star-M tested the drill bits extensively for accuracy, drilling speed, drilling resistance, wear and durability. The test compared the drill bits from Star-M with alternatives from top European brands. The result is always the same: Drill bits from Star-M have a significantly longer service life and visibly deliver the best results, even after many hundreds of drill holes.

Star-M products are manufactured according to the quality standards that are characteristic of Japan. Every single drill that leaves the factory is checked by hand by Star-M employees.

These drills can be resharpened with a Japanese single-cut file.

Article-No.5SA